Kromer Kraft
| Don Kromer Jr., Owner | 1750 Harding Ave |  |
| Custom Fabrication | Girard, OH 44420 | |
| Computer Modeling | 330-539-5053 | |
| CAD-Hand Crafted Headers | 330-539-5056 Fax |
|
Kromer Kraft
|
|
|
Please print this page, complete the form and fax or mail to us. INPUT SHEET FOR COMPUTER ENGINE MODELING
Name____________________________________________Phone__________________________________
Address__________________________________________________________________________________ Intended use of engine_______________________________ Engine Manufacturer______________________ Cylinder Head Manufacturer and Model________________________________________________________ Bore________________________________In. Stroke_______________________________In. Number of cylinders_____________________ Rod Length___________________________In. Compression Ratio_________to 1 Deck height___________________________In. Pin Offset_______________________________ Firing angle between paired rods_________deg. Big end rotating weight of rod___________grams Pin end reciprocating weight of rod______grams Critical load across top dead center_________________
(If unknown tell us the rod size and manufacturer, including the bolt size.) …………………………………………………………………………………………………………………………………………………………………………... Smallest cross sectional area of Intake port_________________sq. in. Intake Valve Size________________________ Number of intake valves per cylinder_________ Entry area into the runner ______________sq. in Valve stem size___________________________ Total Runner length ____________________ in. Plenum to Valve.__________________________
………………………………………………………………………………………………………………………………………………………………………………... Smallest cross sectional area of Exhaust port________________sq. in. Exhaust Valve Size_______________________ Exhaust Valves per cylinder_____________ Primary Header length____________________ Primary Header Inlet Diam.________________ Collector Diam._______________________ Primary Header Diam. At Collector entrance_________ Collector Length______________________
……………………………………………………………………………………………………………………………………………………………………………….. Lift Intake Exhaust Cyl. Head flow in C.F.M. @ 10² , 25² , or 28 ² of H2O ________ ________ _________
(Circle one please) __________ __________ ___________ A complete flow sheet from .100 to over the lift of your cam __________ __________ ___________ is best—please feel free to attach one or use the back of this sheet Induction system used carb.______________ Size information fuel injection_____________ blower________________ C.F.M. of Induction Sys.___________________ Fuel Used____________________
Cam type ( ) Solid ( ) Mushroom ( ) Roller ( ) Hydraulic Intake Exhaust Rocker Ratio _______ _______ Duration at .006_______ ________ Valve Lift _______ _______ Duration at .05 _______ ________ Lobe centerline _______ _______
( A cam doctor file on disk is best. Attach a copy of your cam card, or copy on back) Best R.P.M. for torque peak_________________ Horsepower peak________________________
Please be truthful. Proper input makes this an accurate way to try new ideas without buying every part, and helps you get the most out of parts you already own. Leave blanks rather than guess. On another sheet, tell us more about your car (stick or automatic, weight, etc.) or anything else relevant to your project. |
|
If you cannot use the Java buttons on the side, please use the
following. They will take you to the same places.
|